Patella Tendon Support #7155

This knee support incorporates a pad to unload the patella tendon. This pad is connected to straps which are inserted through D-rings on each side of the support. Since the strap and pad attach only in the front, the support does not constrict circulation. The hook & loop closure above and below the patella limits migration of the support. The discreet design makes the support ideal for wearing under pants.

Indications

Jumper’s Knee, Osgood Schlatter's Disease.

Sizes

Fits Left of Right. Measurement taken around the center of knee, mid patella.

Small:		13 - 14½"
Medium:		14½ - 15½"
Large:		15½ - 16½"
X-Large:		16½ - 17½"
XX-Large:		17½ - 20"

How to Apply the Patella Tendon Support

Open all support straps. Wrap the support around the knee with the logo on the bottom, in back.

Secure the support by attaching the top straps together above the knee.

Take the right hook on the bottom strap and pull it through the slit on the support.

Bring the strap through the D-ring on the outside of the support.

Position the pad over the patella tendon. (The space just below the kneecap.) Attach the hook & loop closures below the knee.

Adjust the pressure on the patella tendon by adjusting the two hook straps [(A) and (B)]. Next, attach these straps to the loop piece in front. Be sure not to tighten too much. Slight pressure over the tendon is usually adequate.

Washing Instructions

Close the hook & loop straps before washing. Hand wash in warm water with a gentle detergent. Blot dry between two towels then let air dry.

Note: If the patient is allergic to latex, please consult a physician before use.